␡
- 1-1 Introduction
- 1-1 Introduction
- 1-2 Tabs and Panels
- 1-2 Tabs and Panels
- 1-3 The Command Line Window
- 1-3 The Command Line Window
- 1-4 Command Tools
- 1-4 Command Tools
- 1-5 Starting a New Drawing
- 1-5 Starting a New Drawing
- 1-6 Naming a Drawing
- 1-6 Naming a Drawing
- 1-7 Drawing Units
- 1-7 Drawing Units
- 1-8 Drawing Limits
- 1-8 Drawing Limits
- 1-9 Grid and Snap
- 1-9 Grid and Snap
- 1-10 Drawing Problem
- 1-10 Drawing Problem
- 1-11 Save and Save As
- 1-11 Save and Save As
- 1-12 Open
- 1-12 Open
- 1-13 Close
- 1-13 Close
- 1-14 Exercise Problems
- 1-14 Exercise Problems
This chapter is from the book
This chapter is from the book
This chapter is from the book
This chapter is from the book
1-5 Starting a New Drawing
When you start a new drawing, AutoCAD assigns a drawing name. The drawing units are specified, the drawing limits are modified, if needed, and Grid and Snap values are defined. The following four sections show you how to start a new drawing.
